How to configure PB Printer to work through USB Cable ?
HOLD BOTH STATION1 and STATION2 BUTTONS IN THE PRINTER
Switch on the printer
Leave the Buttons
Insert the paper into the printer
Automatically Printer will take the paper inside and a message will be printed as follows
STATION 1-CONFIRM STATION 2=SKIP PRESS LOCAL TO CONTINUE
Press LOCAL and then STATION 1
The Default Configuration will be printed as follows
MENU : CONFIG Press STATION 1
DRAFT SPEED: NORMAL Press STATION 1
LQ TYPE: NLQ1 Press STATION 1
PAPER WIDTH: FIRST LINE Press STATION 1
BUZZER: Y Press STATION 1
INTERFACE By default SERIAL or COM1 will be there Press STATION2
Till USB is printed and then Press STATION 1
USB EMULATION By default OLIVETTI will be there Press STATION2
Till IBM is printed and then Press STATION 1
PLUG&PLAY: N Press STATION 1
PAP.EDGE DECTEC.: N Press STATION 1
SPECIAL FORMS: N Press STATION 1
PRINT MODE STANDARD Press STATION 1
BIM MODE: MONO Press STATION 1
PNS SELECTIONS: N Press STATION 1
SAVE PARAMETERS Y Press STATION 1
MENU : CONFIG
Leave the paper in the printer and switch off the printer (Press power button in the PB printer)
SWITCH ON THE PRINTER
Automatically the paper will be ejected
THE SAME METHOD MAY BE USED TO CONFIGURE SERIAL OR COM1 PORT
Thanks to :